what is broken conductor indication
Answers were Sorted based on User's Feedback
If suddenly current in one phase of the line falls then there me and fault that particular phase got opened this will be detected by broken conductor protection by measuring the ratio of negative and positive sequence currents. in simple it is open circuit fault
Is This Answer Correct ? | 0 Yes | 0 No |
<a href=" https://www.electricaltpoint.com/wave-trap-line-trap-working-construction-features-use-in-hv-trasmission-electricaltpoint/ "> Wave traps </a> or <a href=" https://www.electricaltpoint.com/wave-trap-line-trap-working-construction-features-use-in-hv-trasmission-electricaltpoint/ "> line traps </a> are used between the transmission line and power station to avoid carrier power dislocation in the power plant and cross talk with other power line carrier circuits connected to the same power station. They offer high impedance to carrier frequencies but pass 50 cycles power currents easily. They can be resonated at a single carrier frequency with a parallel capacitor. The tuning capacitors are protected against the surge voltages by a spark gap arranged in parallel
It is connected series with <a href=" https://www.electricaltpoint.com/radiant-heating-infrared-heating-and-induction-heating-eee/
"> transmission line </a>. it used for communication purpose. It will block the high frequency signal (communication signal) and allow the low frequency (power).
Is This Answer Correct ? | 0 Yes | 0 No |
which type of capacitors using in single phase motors
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
I NEED RRB CHENNAI (JE ELECTRICAL) QUESTION PAPER FOR LAST 5 YEAR AND I NEED RRB (JE ELECTRICAL) SYLLABUS.PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
12 Answers DFM, Hindustan Unilever Limited, JE, Pace, RRB,
Rotor is taken away from three phase induction motor and three phase supply is given to the stator.What will happen?
We store the d.c supply...then why can't we store A.c supply???
Why compensation is necessary in feedback control system?
why test lamp didn't glow across 500v megger?
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
short notes on npn & pnp transisitor..........
why phase to phase voltage is 400v while phase to neutral is 220v?
What is thyristor?
which type of material is used for making motor encloser