What is rtd output signal

Question Posted / michmach

4 Answers
17267 Views
Nestle, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What is rtd output signal..

Answer / ram asati

RTD OUTPUT ALWAYS RESISTANCE
FOR PT-100 RTD 0 Centegret -100ohm

Is This Answer Correct ?

22 Yes

0 No

What is rtd output signal..

Answer / rajach

resistance

Is This Answer Correct ?

13 Yes

0 No

What is rtd output signal..

Answer / astik gedekar

Resistance (ohms)

Is This Answer Correct ?

11 Yes

0 No

What is rtd output signal..

Answer / afsar mumtaz

ohms

Is This Answer Correct ?

4 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?

0 Answers

there is one orifice plate already installed on 3" line, but my previous engineer(who is not working here) removed that tx, but now i want to take it in to the process, so now what i have to do now? flow fluid is hytherm oil of temp. 260deg & pressure is 3bar.

2 Answers

How many types of sensors are used in instrumentation & what are names

1 Answers CTC,

how to calculate temp.prapotional to mv in thermocoulpe.

2 Answers Electronics, KNPC,

what does mean by analog output trim and where this one used for?

1 Answers

What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?

2 Answers

Why we are using thrust bearing at turbine side?

3 Answers Edac,

How do you calibration D.P transmitter? ?

2 Answers Power Plant,

In control valve there are two type of valve seat we can use metal to metal seat & soft seat.On this valve seat i have following doubt. 1)I have never seen practically the internal assembly of valve so my doubt is that basically weather the seat is soft seat or metal its basic MOC is same as valve body(SS or CS) only in soft seat we are using PTFE ring & place on valve seat & in metal this PTFE ring is not threr am i correct??????? 2)what are the common general rule for using metal to metal seat & soft seat,means its depend on process parameter like liquid,gas, steam & on valve leakage class.

1 Answers

what is maximum vaccume?

4 Answers

I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .

0 Answers

Why Differential pressure transmitter is located below the tappings points for steam & condensible vapor flow measurement application?

2 Answers

For more Instrumentation Interview Questions Click Here