We select 10mm nominal thickness for Elip head of a pressure
vesel. The minimum thickness after forming is 8.2mm. (Shell
thickness is 8mm. The minimum thickness after forming is
satisfied or not with UG-79 (d)(3) in ASME SECTION VIII,
Div.1?
No Answer is Posted For this Question
Be the First to Post Answer
If a fixed gear having 200 teeth is in mesh with another gear having 50 teeth.The two gear are connected by an arm.What will be the number of turn made by the smaller gear for one revolution of arm about the center of bigger gear? Any effort is appreciable witha proper logic..
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
What are sleeve and cotter joint?
Difference between Energy and Exergy? Any practial Example??
How can heat be applied to acrylic?
why mechanical engineering?
position of check valve and valve ,how to arrangement of valve before check valve in pump station.
How to stoped water tube boiler
• How can you justify it?
How the analyses and calorific values of fuels can be reported ?
how hydraulic power stearin clutch work plz explain
can we use light duty vehicle axle into the heavy duty machinery axle ? if no then why?