area under P-V diagram indiacates what?
- 10 Answers
- 11228 Views
- APGenco, Ford, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / devanesan
it is depending on the process. in non flow process under
the curve is work done by the system. in study flow process
the work done is left side area of the curve. please refer
book. w(non flow process)=integaral of P*dv
w(flow process)=integaral of -V*dp
| Is This Answer Correct ? | 13 Yes | 0 No |
Answer / guest
the all engines are aplied to a pressure and volume to
depend so which type cycle operate to a engine
| Is This Answer Correct ? | 6 Yes | 7 No |
how to measure static charge in processing of expandable polystyrene. explain - Units of static charge
what is the difference between suction lift & suction head?
How much resistance is offered to heat flow by drop wise condensation ?
rrb junior engg mecf questine papers
What is the role of silicon as alloying element in steels ?
What will happen if there is moisture in refrigeration system
What is the function of mouth ring
what is difference between (pressure and stress), (sencitivity and efficiency) .
What is pour point?
the compression ratio of petrol engine is always less than c.r. of deseal engine why?
Which element causes difference in higher and lower heating values of fuel ?
how determine the capacity of refrigeration system? how we use condenser coils, compressor, capillarity,compressor
-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
