Answer / 7anoter4

Usually a vertical grounding electrode –made of copper,
copperweld steel, stainless steel or else-and length of 3-20 m
is driven in earth and the upper end will be exposed in a pit
covered by a lid- about 0.3-0.6 m deep and 0.3 m diameter.
This pit facilitates electrode connection with horizontal
grounding conductor and as a check point of electrode state-
grounding [earthing] resistance measurements and other.

Answer / er. s.manimaran b.e(eee)

it is longest copper bar which is burried into earth .and
its connected to main earth wire of utility.

how to find the ballast lost from the actual wattage? for example i am going to buy decorative type 2x36watts fluorescent light fitting for this lamp how to find the ballast lost? is there any formula?

2 Answers   MEIL,

---

How to improve the power factor from 0.8 to 0.98? Also tell me cost vs benefit analysis.

2 Answers  

---

what is the CT of protection and CT of metering ? what is class 5P10 & 5P20 and class PS ?

16 Answers   JEE Main, ONGC, VRA,

---

what is the full form of KVAR

6 Answers  

---

How many speed of dg start motor for engine starting time

1 Answers  

---

How to calculate energy stored in a capacitance

0 Answers  

---

Whot is the difference between MCB and MCCB.Whot is the selection critearea for MCCB and MCB for 63 Amp.

5 Answers  

---

Why collecting electrode of ESP to be earthed

0 Answers   NBVL,

---

How to specific gravity of battery will check, i didnt saw any hydrometer. & say me how to dip into the battery what are the specifications are given in the hydrometer?

1 Answers  

---

back emf of motor at the time of starting ?

2 Answers  

---

What r the specification furnishid in motor name plate?

5 Answers  

---

what is power system.........?

1 Answers  

---