Answer / ankit

DBSE MEANS DISTANCE BETWEEN SHAFTS END

Why are not use ball bearing insted of roller bearing?

0 Answers   Ravi Biotech,

---

the specific work input during a compression cycle from p1 to p2 , if compresion is isothermal, is given by p1v1logp2/p1. explain?

1 Answers  

---

what is critical speed?

32 Answers   Power Grid, Reliance, Takreer,

---

Which pipe should I use SAW, ERW or seamless if I have the following constraints I have to transport methane gas Size is 8” Corrosive environment Sulphide is present Also tell the cost comparison

0 Answers   SMEC,

---

PLESE SEND ME OLD TECHNICAL N APPTITUDE QUESTION PAPERS

0 Answers   HPCL, TCS, Urjanet,

---

What is the name given to portion of thermal energy to be necessarily rejected to environment ?

0 Answers  

---

why does polytropic efficiency of a compressor decrease with increasing flow rate ?

0 Answers   L&T, ONGC,

---

A vertical plate and a horizontal plate are suspended in an open room. Both are heated to the same temperature. Which one will cool first?

11 Answers   BARC,

---

dear sir, please send me HPCL(mechanical stream) papers to my email-id(shravani.mech@yahoo.co.in) as soon as possible.

1 Answers  

---

effect of temperature on stainless steel,aluminized steel,chromium at (500C-750C)-required for project work on silencer 1.thermal conductivity 2.heat conduction 3.mechanical strength 4.temperature to weight ratio urgent

0 Answers   Essar,

---

what is the meaning of rheostat in maximum and minimum position?

0 Answers  

---

Is Solid work and solid edge best programs for drawing? what is the difference bewteen them? r there better softwares?

0 Answers  

---