Interested to Buy Any Domain ? << Click Here >> for more details...
How can you limit the fault level in a power system?
- 1 Answers
- 4548 Views
- Alfanar, I also Faced
- E-Mail Answers
Answer Posted / wasim
By inserting current limiting reactor in series with line.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
What is I to C?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
what is class of SPD and dittels of all class ?
What is the difference between acs 550 & acs 850
Define damping ratio.
i need previous entrence exam papers of nhpc.
What is open loop and control loop systems?
define as synchronous generator
what is a synchronizing lamp ?
Explain the fundamental difference between emf (electro motive force) and pd (potential difference) ?
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
why the neutral point in connnection oscillates?
how can i reduce sparking without stepdowning the voltage
