how do the stepper motor works.

1 Answers   Vardhman,

---

What is Class and accuracy in CTs? Types of Classes and important of Classes?

2 Answers  

---

how rectifier transformer work in electroststic precipetatore(esp?

0 Answers  

---

if an alternator or turbine using fuel to produce ele energy and we didn't connect load to the ends then where was gone the ele energy

2 Answers  

---

What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw

0 Answers  

---

1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

0 Answers  

---

what effect on electrical equipment if PF is gone over 0.996 in leading when provider say that its keep in minimum 0.996lagging

3 Answers   ABB,

---

please explain to me how to calculate current,voltage,resistance with formula??

0 Answers  

---

WHAT HAPPENS IF FUSE IS CONNECTED TO NEUTRAL WIRE

5 Answers  

---

hi friends this is a newcomer in your community of enthusiastic peoples. i am preparing for SSC (CPWD JUNIOE ENGG EXAM FOR ELECTRICAL) pls guide me on the same how to crack it? PLS LET ME KNOW IS ANYONE THERE WHO PASED IT? CAN I GET THE QUESTION PAPERS OF PREVIOUS EXAMINATIONS?

0 Answers  

---

for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?

0 Answers   Power World,

---

What are gain margin and phase margin?

0 Answers  

---