will there be any problem by recovering slip from single
phase induction motors?
No Answer is Posted For this Question
Be the First to Post Answer
What is non-minimum phase transfer function?
If the capacity of water Tank is 50000 Liters situated at 20 meters height from ground level,What would be the size of pipe and how much USGPH water will be supplied and what will be the motor or pump rating used for this work?Illustrate by showing formula?
WHICH TYPE OF TRANSFORMER IS USED IN POWER TRANSMISSION BASED ON TRANSFORMER CONNECTION ON PRIMARY AND SECONDARY SIDE
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
what is the thumb rule for determination resistance of resistor?
what is the function of choke in tube
what is the abbreviation of MIMIC regarding control and relay panels of power systems????
Is there any option to replace two Genset of capacity 125KVA with one higher capacity for same office?
There is any especial requirement for motor to drive through with VFD?
415v 14kw so can u tell me how i can measure the cable size.then size of the earth also
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
My load is 1635 KW. & current pf is 0.884, I have to improve it for 0.99.Please suggest what KVAR value is needed?