what voltage to be select in megger for insulation resistance testing to L.V , H.T cables,motors and transfomer?and ohms valve should be giga ohms only or what?

1 Answers   Deevya Shakti Paper Mills,

---

how to calculate insulation level of transformer?

0 Answers  

---

if we supply DC power to AC transformer then what its result?

15 Answers  

---

how a generating station can monitor its multi users power factor. What type of incentive /penalty is associated with power factor management.

1 Answers   Sojex,

---

different between electrical and electronics Engineering????

4 Answers  

---

1. How many types of mangers? 2.How many types of capacitors? 3.pls tell me normally types alternator problems?

0 Answers   APCPDCL, Voith,

---

what do you understand by dressing a HT/LT pole

1 Answers   Federal Polytechnic Nekede,

---

how we select ac fuse rating of an power inverter???

0 Answers   Simco,

---

(1) From the following option, which option is correct for largest size transformer.? a)1KVA,25Hz , b)1KVA,50HZ , c)1KVA,60Hz , d)1KVA,100Hz

5 Answers   Torrent Power,

---

how to calculate load if i have three phase & single phase connection from power transformer( in term of kw & kva).can i take single phase load/3 for total kw calculation

1 Answers  

---

One of our gas turbine generator unit "1st stage rotor ground fault" alarm was occured several times. we tried to measure some voltage vulue ground fault protection relay (UNS3020a made by ABB and we measured the value of: Ground: 0.9VDC 5V: 5.8VDC 24V: 23VDC u+: 300 – 350mVAC Rf1: 17.5mVAC Rf2: 17.6mVAC The unit still running and the alarm was reset. As of 6pm yesterday and unitl now no alarm happened again. I our protection relay was defective?

1 Answers  

---

What is the function of interposing current transformer?

0 Answers  

---