Answer / omak

RTD: Resistance Temperature Detector,
Principle: Every metal has its own different characteristics. wen a metal undergoes heat then its electrical or mechanical characteristics will change proportionally.
In case of RTD, wen it undergoes heat then its electrical characteristcs will change proportionally.By measuring the resistance,we can find out actual temperature.

Thermocouple: thermocouple is working on the principle of Seeback effect. two dissimillar metals are combined together and forms two junctions(Hot and Cold). wen applying a heat on the one junction there is an output as milli volt. by measuring the milli volt, we can calculate the temperature with known reference temperature(cold Junction).

hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q

1 Answers  

---

What is the purpose of RS Networks

2 Answers  

---

protection relay watchdog contact operation?

1 Answers   L&T,

---

HI friends.I am Surya a BTech in Electronics and Instrumentation Engineering.I am going to appear Relince Industries Ltd all India writen test very soon. so plz help me by sendind the probable questions about my subject.My mail ID is surya.barik@gmail.com.

1 Answers   Reliance,

---

What is mean by SMART in an Instrumentation. is any full form for SMART?

3 Answers  

---

why are set -10vdc in bently neveda vibration system.

4 Answers  

---

please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826

0 Answers  

---

our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS

1 Answers  

---

HELLO FRENDS ,, I M IN THE MIDST OF TROUBLE .. JUST LITTLE HELP ME... SUPPOSE ,, I HAVE A CLOSE VESSELE TANK ( HEXANE MEDIA ) ,, I M USING ROSEMOUNT 2051 DPT FOR LEVEL APPLICATION .. ITS CALIBRATE RANGE IS.. . 0 TO 950 MMH20 ..I DID CALIBRATED DPT WITHOUT REMOVING IMPULSE LINE OF HIGH AND LOW TAPPING.. & WITHOUT DISTURB 3 WAY MANIFOLD..!!! BUT ,,, DURING CALIBRATION I SELECT RANGE BY HART LRV IS 900 MMH20 & URV IS 1300 MMH20 ,, BUT ,TANK LEVEL SOMETIMES 100 % AT 1100 MMH20 , SOMETIMES 1300 MMH20 ..IN THIS CONDITION .. WHOLE LOOP FAILED ,, MAIN THING IS THAT ,, HOW TO CUSTOME RANGE SELECT ?? AND IF I USED RANGE OVER THE ORIGINAL CALIBRATE RANGE ,,,THEN WHAT ERROR WILL BE COME ??? HOW TO ZERO CALIBRATION OF DPT... HOW TO ZERO TRIM BY MANIFOLD ?? AND FOR TANK LEVEL PURPOSE ... WHICH UNIT I CAN USE ??? IS THERE ANY CALCULATION OR CALIBRATION .. IF YEH .. THEN PLZ JUST GIVE ME CALIBRATION STEPS FOR DPT.. THANKS YOURSSSSSSS

1 Answers   Torrent Pharma,

---

Give Detail information about plc,dcs,and scada system?

1 Answers  

---

what is beta ratio?

3 Answers  

---

what is difference between modbus & fieldbus

1 Answers   ABB,

---