Answer / annonymous

Usually we dont lay any type of cables in the maintenance bay, but you can lay it, but make sure it does not physically interfere with the maintenance activities i.e. equipment handing etc. or block the access ways there.

Also, your client may also not permit you to do so.

In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?

1 Answers  

---

what will happen if ac motor given dc supply?

1 Answers  

---

Transfer of electric power from primary to secondary in a transformer takes place A electrically B magnetically C electro-magnetically D conductively

2 Answers  

---

what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer

1 Answers  

---

when we connect the capacitor banks in series with the circuit?

3 Answers   Cipla,

---

In Power transformer oil temperature or winding temperature will be high

3 Answers  

---

what is the speed of current

4 Answers  

---

Explain Power factor in simple words

1 Answers   ETO,

---

how we masure a cuurrent?

5 Answers  

---

I want to ask a question which i faced during testing of Capacitive Voltage Transformer in AIS. We have measured the C1 , C2 individually , but when we start to measure the total C1+C2 , the testing equipment shuts down and says low loading. Kindly is it possible to find the total capacitance by using measuring device. kindly briefly explain the procedure.

0 Answers   AIS,

---

how does an open delta transformer works

2 Answers  

---

what is the function of an auto reclosure relay in OHL?

1 Answers  

---