Answer / simon

The another name of open delta is v-v connection.In it the Prim & Sec winding has only two windings. As compared 4rm delta delta x-mer only 58% turns r kept. it is used for low v &low power 3 Phase x-mer .

Answer / k.prakashchandra

Open delta is made with only two single phase transformers
which are connected in series. Two phases for two free
terminals and the third phase to the common point.The output
power will be restricted to 87 % of the total capacity.You
will get 3 ph 3 w secondary from 3 ph 3 w primary

what is use of reactive power in ac ckt.

2 Answers  

---

PLEASE SEND THE PREVIOUS YEARS QUESTION PAPERS OF RRB JUNIOR ENGINEER-ELECTRICAL

0 Answers  

---

what is the voltage between earth & neutral in 3 phase electrical connection.

0 Answers   Megatron Solutions, SIPL,

---

in a diesel generator is there any relation between AVR to fule system?

2 Answers  

---

for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance

0 Answers  

---

What is touch potential and step potential?

0 Answers   IRI,

---

why we use 50 hz frequency in india .. why not 60 hz 

3 Answers  

---

3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?

0 Answers  

---

what is the installation process for lifts

0 Answers   DLF,

---

What the reson for frequant instantaneous ground over current fault in our sync. Generator... 15 triping in 24 hr...

1 Answers   HCPL, Jhunjhunwala Vanaspati Jhoola, Regen Powertech,

---

How is the AVR working?

1 Answers  

---

What are the various methods for effecive earthing in a factory in a rocky terrain, where soil resistivity is extraordinarily high? The usual method of 3 m deep earth pits is not serving the purpose.

4 Answers  

---