Answer / sk

Remote seal transmitters are used to keept the process and
transmitter isolated from each other.

Foe selecting control valve if i have the min,normal & max data of flow rate,inlet pressure& outlet pressure,inlet tem.&density than how can i assure that these data are correct,pl. let me know if therew there is any method to check it.& also how we assure that the Cv we get from this data is suitable for valve for controlling require flow.

3 Answers   HPCL,

---

How do you calibration D.P transmitter? ?

2 Answers   Power Plant,

---

temptrure me ketne frequiency hote hai

0 Answers   ME,

---

If a transmitter is installed 10 m below its tapping point how much pressure exerted if fluid is water?

10 Answers   QAFCO,

---

What is the reason for not giving very High Proportional Gain Kp in PID Controller?

2 Answers   ABB,

---

How do bending tubing provide better measurement than using tubing fittings such as elbows?

0 Answers  

---

relation between flow and differential pressure.

7 Answers   ABB,

---

Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?

0 Answers   Process Control Technologies,

---

I have applied the post Junior Engineer-(TM)in R.R.B CHANDIGARH recently . what type of question i have to practice and which book ?. can i get any model question paper?

3 Answers   RRB,

---

How to calibrate the flow transmitter

0 Answers  

---

what do you know about Foundation Fieldbus?

1 Answers   CCIE,

---

An RTD is a_________________________.it works as follows

2 Answers  

---