what is the difference between 2 wire and 3 wire RTD- application wise,cost effectivity?

2 Answers  

---

A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer

0 Answers  

---

how to commission furnace ( water heater)

0 Answers   Petrofac,

---

I am a electronics and instrumentation fresher trying for a job in IT sector. what do need to prepare for the interview?

2 Answers  

---

Where do we consider the pressure in mbar & where do we consider the pressure in bar & why is it so ?

2 Answers   BOC, Jindal Steel and Power,

---

what is the T/C & RTD mesuremaint?

3 Answers  

---

Relation in MMWC to Flow rate

1 Answers  

---

y v r connecting 250 ohms resistor in series when u cummunicate with BT in bench calibration?

5 Answers  

---

What is the difference between relative vibration

4 Answers   Desein,

---

given a processor batch of 1000 resistors moving on the conveyor belting in a large factory. the resistors is value at 10k ohms each but when the resistors reach the quality control, some of the resistor has been rejected caused by failure in manufacturing.the high quality measurement is used to determine the failure. describe the instrumentation terminology in measurement of a system above with explaining the important in:- -reliability -sensitivity -repeatability -precision -range -resolution -linearity -hysteresis -error -accuracy (answer must related to the scenario above)

0 Answers  

---

What should be hight of CONTROL panel for access & OPERATION What is BIS & INDIAN STD for SAME?

3 Answers  

---

in split range control valve,two valve should be in two different line and that should have some distance,and we have only one positioner feed back link.so how we connect one feed back in two control valves?if you have picture please forward me.my email id kb.syamkumar@gmail.com

2 Answers  

---