what is the differance between Analytical and semi micro
balance?




Answers were Sorted based on User's Feedback



what is the differance between Analytical and semi micro balance?..

Answer / rahul1

By the analytical balance we can mesurd spl in gram & by micro we can in mg

Is This Answer Correct ?    7 Yes 2 No

what is the differance between Analytical and semi micro balance?..

Answer / tapan shaw

For assay we can use microbalance because we have to take
weight of any sample in microgram level. In analytical
balance the minimum weight to be taken 60 mg. So for lower
level(specifically below 60 mg) microbalnce should be used.

Is This Answer Correct ?    4 Yes 4 No

Post New Answer




More Analytical Chemistry Interview Questions

Why linearity of detector performed in HPLC calibration

2 Answers   Cipla, Intas,


In Karl Fischer titration,What is the situation if the material tested is only soluble in water,and not soluble in the common solvents used such as methanol ?? [e.g. Iron III Hydroxide polymaltose]

0 Answers  


define polar and non polar solvent

2 Answers  


Column selection in HPLC method development?

1 Answers  


what is karl fischer principle and reaction ,describe it

5 Answers   Microsoft, Jubilant Organosys,






What is the difference between bulk property detectors and Solute property detectors vivimed labs limited

3 Answers  


all types of questions asked at the cipla interview

0 Answers   Cipla, Graviti Pharmaceuticals, Calyx, Aurobindo,


In GC and HPLC ,how we can decide which of following method will be suitable or use for quantitation of chromatogram at the time of method development. 1.Area Normalisation 2.External standard method 3.Internal standard method

1 Answers   Atul,


How do we get end points and how many end points are possible for citric acid and di-acid not theorotically answer should be given practically.

0 Answers   Reddy Labs, Hetero,


HPLC Calibration was done in Reverse Phase, but not in normal phase why explain?

11 Answers   Cipla, Orchid,


If mass balance is not passing in forced degradation in method validation that method is suitable or not?

1 Answers   Dr Reddys, Reddy Labs, Aurobindo, Wockhardt,


Calculate the water content in Di Sodium Tartrate (DST) based on molecular weight?

2 Answers  






Categories
  • Organic Chemistry Interview Questions Organic Chemistry (289)
  • Inorganic Chemistry Interview Questions Inorganic Chemistry (113)
  • Analytical Chemistry Interview Questions Analytical Chemistry (1215)
  • Physical Chemistry Interview Questions Physical Chemistry (62)
  • General Chemistry Interview Questions General Chemistry (300)
  • Chemistry AllOther Interview Questions Chemistry AllOther (77)