Answer / carl_ellis

HART can be used to write setpoints to or to read position
or diagnostic information from HART enabled positioners on
control valves.

But it takes either a very high end PLC with HART I/O or a
DCS with HART I/O and the accompanying software application
to do so.

On the other hand, HART is routinely used to configure valve
positioners, for instance, either basic setup or more
sophisticated tasks, like entering a set of values for a
valve position characteristic table.

Carl Ellis
Measure First

send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com

0 Answers   HPCL,

---

what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?

0 Answers  

---

what is the difference b/w magnetic flow meter&mass flow meter? which one is best?

1 Answers  

---

Dead weight tester & comparator for calibration , which is more accurate , what is the application.

1 Answers   Bapco Bahrain Petroleum Company,

---

What is the role of Integral in pid control?

6 Answers  

---

How much flow is passing through 6 inch line? There are no gauge, no any transmitters in line.

3 Answers  

---

How to check the SCAN time of DCS ,n dont give therotical answers .How to check the SCAN time of DCS during FAT?

2 Answers  

---

how to know the URL and LRL for steam drum level and why the calibration range is in negative ?

1 Answers   JSW, Samsung,

---

we are using centum vp as monitoring with Dell precision work station T3600 but some times PC(s) are restarted automatically . how we can solve this problem? thanks

0 Answers   Oil India,

---

Please explain the difference between instrument range and calibration range in terms of pressure transmitter? line design pressure: 93 bar operating pressure : 82 bar press Transmitter Range? calibration range ?

3 Answers   L&T,

---

Different between control valve and mov

2 Answers  

---

What is the standard height for stancion supports?

4 Answers  

---