Why we use modulus with voltage in stability equation that is P=[E][V]SIN@/X W

Why we use modulus with voltage in stability equation that
is P=[E][V]SIN@/X WHY VOLTAGE IS IN MODE VALUE WHAT IS THE
REASON?

Question Posted / s.kumar2011

1 Answers
3378 Views
Bhel, I also Faced
E-Mail Answers

Why we use modulus with voltage in stability equation that is P=[E][V]SIN@/X WHY VOLTAGE IS IN MOD..

Answer / sarmadahmed

Because the sign is taken care by the angle and we only need the magnitude so mod is taken.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

what is the diff between earth leakage relay and earth fault relay?

7 Answers

what are the interview question asked in wind mill about electrical

0 Answers

what is the diffference between 3 point and 4 point starter ?

3 Answers

A 3PH MOTOR RUNNING IN NORMAL CONDITION AND ITS AMPERE ALSO UNDER ITS FULL LOAD CURRENT,ITS CABLE RATINGS ALSO HIGER THN ITS CAPACITY,BUT ITS CABLE GETTING ABNORMAL HEAT(NOT TOO HOT)WHY ITS GETTING HOT LIK THIS?

5 Answers

Construction of ac motor?

1 Answers

hi friends how 3 phase converter functioning ?what is working principle of rotory phase converter ?

0 Answers

is it possible to test of bus bar in high rise building without completed full floor ?

0 Answers

What is the function of under voltage release ?

0 Answers

i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400

0 Answers

What is knee point voltage of transformer?

0 Answers Nabard,

i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?

0 Answers

Is there any difference of regulation of transformer, alternator , transmission line, if yes, what is it?

1 Answers

For more Electrical Engineering Interview Questions Click Here