Answer / muruganp

What is use of earth bits?
Earth is 2 type 1.neutral earth 2.body earth neutral earth called us parallel in phase for any load its not parallel in phase any electrical equipment was not working. body earth is called us it is connected to only electrical machine body any leakage current passed in machine body reduced to earth side so avoided electric shock .
Neutral earth value?
Neutral earth value is 5 ohm individual .combine neutral earth value less than 1 ohm.
How to improve earth value?
methods:
1. earth bits side add water and salt ,chemical powder in weekly once.
2. check weekly once for earth bus bar bolt net any loose condition.
3. only using pipe earth.
4. pipe earth max length 10 feet using better .
5. maximum avoid old earth bits.
6.more than 2 earth bits combine better.

Answer / sakthivel perambalur

your question is what is use of earth pits,

my answer is to discharge the electric current

next your question how it will function,

my answer is in our earth is a good conductor in electricity so, when ever fault developing time fault current goes to earth electrode and then goes to discharge to ground,
.
next your question is what is earth value,

my answer is zero,

next your question is how we are improve our earth resistance

my answer is to maintain dry condition in your earth pits and don't maintain the earth bit OK.

Answer / hany goda

any one can help ( wt is the use of( keeping rod tied wz cable ) exposed ?

to measure fault current ? how ? and if as per site condition consultant ask to remove earth pit housing and buried wz concrete ? so wt to do if all are buried in concrete to measure fault current especially for transformer and generator ?

1.What is the maximum transmission voltage in india & where it is located? 2.more information about indian power scenario.

4 Answers  

---

How does frequency affect KVA rating of a transformer? If a 500 kva, 500 to 250 v, 60 hz t/f normally used in Canada is to be operated in Europe on 50 hz frequency then how will its KVA rating change? a-increase b-decrease c-remains same

1 Answers  

---

Does the direction of rotation of d.c. Shunt motor would get reversed if the armature current and field current both are reversed?

0 Answers  

---

In Panels Main Incomer considered should be TPN or FP?

2 Answers  

---

what is the highest voltage for transmitting electrical power in india

5 Answers  

---

What do you mean by reach and reach the point of the relay?

0 Answers  

---

what happens if the phase sequence of parrlel connected sys will changed & phase displacement

1 Answers  

---

Salient pole alternator is more stable, why?

0 Answers  

---

Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me

0 Answers  

---

Why is DC use instead of AC for protection and control circuits?

4 Answers  

---

WHY CAPACITOR IS NOT USED FOR THREE PHASE MOTORS DURING STARTING

1 Answers   Quest,

---

how to calculate ups and battery rating

2 Answers  

---