what is the purpose of using 3-point starter in dc machines?
Answers were Sorted based on User's Feedback
The purpose of using a 3-point dc starter in a dc machine
is to limit the starting current in the dc circuit.The
starter acts as a resistence in series with the dc circuit
to limit the starting current to the circuit at the
begining & thus acts as a initial protection between dc
rectifier and dc circuit.
Is This Answer Correct ? | 35 Yes | 3 No |
Answer / amulyareddy
To reduce the back emf also we will use the starter
Is This Answer Correct ? | 11 Yes | 3 No |
where multistage pump used
What is the allowable value of IS 2062 Gr.B?
What is an Economizer?
4 Answers ABC Inc, RRB, Siemens,
how to calculate bearing width
what is heat rate of a power plant?
When crude oil heated Which Hydro carbon comes first?
1 Answers Essar, GM General Motors,
WHAT HAPPENS TO THE VOLUME OF SOLIDS BY INCREASES TEMPERATURE OF THAT SOLID
Although the secondary loop of a PWR is a closed loop but some noncondensible gases are entrained into the secondary feedwater. Write three probable sources of these noncondensible gases.
1 Answers Trinity Technologies,
What is entropy
What causes crankcase explosion?
What is under cooling and supercooling?
the compression ratio of petrol engine is always less than c.r. of deseal engine why?