Answer / narmatha

if secondary terminal is open circuited then due to absence
of counter amp-turns of the secondary,the unopposed primary
m.m.f. will be set up an abnormal high flux in the core
which will produce excessive core loss with subsequent
heating and high voltage across the secondary terminals.

Answer / pritesh

if we put ct secondary open circuited than no current will flow through it and also there will be high voltage across it which will damage it

Answer / rahul

A CT Current transformer) is used to reduce the high current on primary for measuring it with small range instruments. So its number of turns on secondary will be high. So if we open circuit the secondary it will results in very high voltage on secondary which in turn damage the CT.

Answer / ayaz ahmad khan

if the secondary terminal is open then no current flow
through secondary due to absence of load

Can a transformer designed for a particular voltage and frequency rating be used for different set of mentioned ratings? Assume that the winding does not get burnt because of overheating at higher voltage. If yes, then under which constraint it is possible?

1 Answers  

---

Why Dyn11 Transformer is selected for distribution transformer?

3 Answers   JK Associates, MSETCL Maharashtra State Electricity Transmission Co Ltd,

---

How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel

0 Answers  

---

What are the various methods for effecive earthing in a factory in a rocky terrain, where soil resistivity is extraordinarily high? The usual method of 3 m deep earth pits is not serving the purpose.

4 Answers  

---

What is the formulae of Megger value for a A.C.Motor

0 Answers  

---

what is the difference between AHU and FCU .

1 Answers   JLL,

---

DIFFERENCE BETWEEN POWER AND CONTROL CABLES

9 Answers   NCC,

---

What happens with squirrel induction machines if the ends of rotor conductors are kept open? Explain

5 Answers  

---

What are the special cables required for explosion proof wiring?

2 Answers   IVRCL,

---

In a house wiring why we are using only one neutral wire and so many phase wires from the main board, when the load is common for both wires?

3 Answers  

---

what is ten delta test? what is the significanse of it

1 Answers  

---

can we measure +,-.zero sequence current ....? if so how can ???

2 Answers   NLC,

---