Interested to Buy Any Domain ? << Click Here >> for more details...
why secondary terminal of current transformer should not be
open circuited?
- 4 Answers
- 10323 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / rahul
A CT Current transformer) is used to reduce the high current on primary for measuring it with small range instruments. So its number of turns on secondary will be high. So if we open circuit the secondary it will results in very high voltage on secondary which in turn damage the CT.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Apparent power is expressed as V * I(Conjugate). Why not in V * I ?
What are the advantages of vscf wind electrical system?
hai friends i have BSNL JTO exam on next month so if any body have model question paper or give preparation tips to my mail id kumar4486@yahoo.co.in this will helpfull for my future .plz & thank u by kumar
what is the role and fuction of automatic transfer switch in rotary ups
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
What will happen if we introduce negative feedback to a control system that uses a positive feedback?
A low wet bulb temperature indicates
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
Can a generator runs after getting 1st stator earth fault.
what is the difference b/w pvc cu conductor and cu breaded wire..?
What is Anemometer used to measure?
What is vacuum circuit breaker.define with cause and where be use it device?
Can any one provide the inspection procedure of MIMIC for VFD panel? Details: If someone wants to have a mimic in the VFD panel what are inputs considered for the mimic(like on,off,trip) whether we are able to add speed variation in the mimic(if so how can we get) and what are the parameters to be checked in the MIMIC during inspection?
