for any load, what happen if we use the cable rating above its normal rating

for any load, what happen if we use the cable rating above its
normal rating

Question Posted / guest

2 Answers
4864 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

for any load, what happen if we use the cable rating above its normal rating..

Answer / krushna ch sahoo

nothing will happen to the load, only the
cost increase

Is This Answer Correct ?

3 Yes

0 No

for any load, what happen if we use the cable rating above its normal rating..

Answer / reddy

No problem with higher
rating. Its safe. Only
cost increases

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

power transmission pole used one support , that only for support or earthing

0 Answers

Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient?

0 Answers

ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]

0 Answers

Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices

0 Answers Mayur,

wath is this mining of dg

2 Answers Nokia,

what is dc voltage?

2 Answers

why CERAMIC material is used in insulators??

1 Answers

WHICH IS BETTER( FOR POWER SAVING)- ON LINE OR OFF LINE UPS ?

3 Answers Punjab National Bank,

1000 W bulb takes 4.16 Amps at 240 volt then what will be the KWH & if i am using 1000 W bulb at 180 Volt the amps will be 5.55 then what will be KWH????????????????

2 Answers

what is the terminal voltage of dc series generator running at rated speed at no load?

2 Answers

What is the selection & Designing procedure for DG/Transformer

4 Answers Crompton Greaves, Sterling, TATA,

regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?

0 Answers Reliance, Southco Utility,

For more Electrical Engineering Interview Questions Click Here