Answer / sa\

voltage is a potential difference betwee two points in an
electricalcircuit.

Answer / ravi kant chaubey

Voltage is an informal term for electric potential
difference,is the energy per unit charge

Answer / imran mohd. qureshi

Voltage, also called electromotive force, is a quantitative
expression of the potential difference in electrical charge
between two points in an electricalcircuit.

Answer / apurbamajumdar

Voltage is a unit of potential difference between two nodes in electric ckt.

Answer / sachin kumar

voltage is a potential difference betwee two points in an
electricalcircuit.
But I think voltage is a source for the follow the electron
in a conducter.

Answer / tej bahadur

Voltage is a potential difference of 2
different potential point in an electric
field which must b at different level

Answer / chanchal

voltage is a potential difference betwee two points in an
electricalcircuit.

How to covert the ac to dc and how to control the dc output?

3 Answers   ABB,

In HT overhead line why should provide top conducter which is not connected whith insulater..?

3 Answers   Essar,

How stabilizer works

1 Answers  

which motor gives constant speed?

7 Answers  

What is Negative Potential Bias

0 Answers   TATA,

what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?

0 Answers  

In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above

0 Answers  

We all have seen transmission and Distribution lines In transmission lines the voltage is high and current is low(to reduce I^2r loss) and in distribution lines voltage is low but current is high however the size of transmission wires is bigger than that of distribution wires even though the amount of current carried by the distribution lines is more than that of transmission lines why?

4 Answers  

can i use 2000/5A Clamp meter to measure HT cable

0 Answers   century, Engro,

What will be MF if we have CT ratio is 130 of 3 nos?

1 Answers  

how to convert single phase supply to 3 phase or 3 phase to single..?

7 Answers   Wipro,

Phase control and integral control are used for?

0 Answers   NPCIL,