Answer Posted / sachin kumar
voltage is a potential difference betwee two points in an
electricalcircuit.
But I think voltage is a source for the follow the electron
in a conducter.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is gridrotor resistance starter
Which motor is 3.3 or 11kV more reliable, in terms of efficeancy,maintenance, reliability.
why impudance relay used for medium transmission power system? why not others?
what will happen if frequency is below 50 hz?
What are the material used for inductance coil?
What is rotary phase converter?
why are u join ntpc
can mini-curcuit supply MIL-tested transformer !
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
What is the necessary condition for stability.
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
When we use 3 terminal resistor?
What is the permissible maximum flux density in transformer core?
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
