5. Two long boundary walls run parallel to each other at a center to center di

5. Two long boundary walls run parallel to each other
at a center to center distance of 1 meter apart. The width
and height of the first wall are 0.30 m and 2.5m
respectively. While those of the second are respectively
0.18m and 3.5m. Plot the distribution of vertical stress
intensity due to walls on a horizontal plane, 1m below
ground level. The walls have negligible depth of foundation
and are made of brick masonry (y = 19.2 kN/m cu)

Question Posted / rajamrizwan

0 Answers
2084 Views
KIOCL, I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Civil Engineering Interview Questions

What is the proportion of cement agg. and sand for M20,M25 and M30?

12 Answers

how to calclate the SHUTTERING TAKEN CONCRETE LOAD? WHAT IS THE LOAD BEARING CAPACITY IN STEEL SHUTTERING PLATE? WHAT IS THE CONCRETE LOAD IN (MASS) IN THE SHUTTERING PLATE. PLATE SIZE IS 120CM* 90CM CONCRETE WALL LENGTH IS 10M ,WIDE IS 60CM, HEIGHT IS 1.2M PLS TO SENT THE CALCULATION.

0 Answers

1. if only 1 slab of a floor get sagged, how could be it repaired? 2. if any footing gives the cube result, after 28 days less than 16 n/mm2 in spite of 20 n/mm2 what are the remedies ?

3 Answers

Calculate the maximum allowable speed on a horizontal curve of radius 350m if the maximum allowable values of the lateral coefficient of friction are 0.14 and the rate of superelevation is 0.08.

0 Answers

how many Concrete hollow blocks (6"x8"x16") will one mason and one helper accomplish/Install a day (8 hrs/day)?

5 Answers Gabriel Construction,

I what know about life time of frp tank plz explain about it specifications & other details

0 Answers

In 1:2:4 ratio how much kgs of cement,fine&coarse aggregates to be used 1cu.m

2 Answers BTCL,

what is meant by structural design

0 Answers

What are the types of slump?

0 Answers

How to calculate measurement box size for M25 grade cement?

3 Answers Perunding Omega PMC,

While Calculating Quantity Of cement,sand,Metal we get cement in no of bags,Where Sand & Metal we get in Meter Cube(M3)how to convert it to Units(i.e in no of lorry's or Tractors )

2 Answers

What is high adherence steel bar? I have a general specification which refers to High Adherence steel bars, coils and meshes to BS EN 10080 and BS 4449 or BS 4483. Is this just general re-bar or is there something different about it? The spec originated in France.

0 Answers

For more Civil Engineering Interview Questions Click Here