What are types of mixs ?
Answers were Sorted based on User's Feedback
Answer / princekapoor
Design mix and Nominal mix
Design mix is that which is achieved by mixing different
quantities of aggregates and binder (Cement) by trial and
error to get the desired compressive strength for say M15.
M15 concrete may not be necessarily 1:2:4 for different
varieties of aggregates.
Nominal mix is the standardized mix achieved by designing
which can be used without further designing in the
prescribed ratios like 1:2:4 or 1:1.5:3. These are never
denoted as M15 or M20
Is This Answer Correct ? | 36 Yes | 2 No |
Answer / shila
Design mix is that which is achieved by mixing different
quantities of aggregates and binder (Cement) by trial and
error to get the desired compressive strength for say M15.
M15 concrete may not be necessarily 1:2:4 for different
varieties of aggregates.
Nominal mix is the standardized mix achieved by designing
which can be used without further designing in the
prescribed ratios like 1:2:4 or 1:1.5:3. These are never
denoted as M15 or M20
Is This Answer Correct ? | 3 Yes | 3 No |
Answer / vijayaraj24
Types of mixing are wet mixing,dry mixing & hand mixing & machine mixing
Is This Answer Correct ? | 4 Yes | 9 No |
pls give me ans to ACT formula cube testing porpuse
The foundations are placed below ground level, to increase?
In built up area basis what is ratio of concrete
How much steel required for 1 sq. meter area?
1 Answers Aditya Constructions,
One plate (women civil worker lifting Plate - Satti) sand measures how many cubic feet?
what will be the grade of concrete for PCC having ratio 1:4:8?
i have span of 6m x 4m how do i calculate the reinforcement of steel i needed and to at what distance and also the thickness of slab. looking forward thank you RAVI
how will i find leakage in underground?
what is the problem not getting 7 days slab cycle in Mivan formwork? what is the output of mivan carpenter per day?
What is the absolute pressure scale?
what is the basic difference between Coloumn & Shear Wall
If 16 mm dia hysd bar of grade Fe500 is needed in a beam but it is not available in the construction site but the beam has to cast in an emergency. Which dia of bar is to be used for for that situation? (If greater than 16 dia bar is not available at site)