Answer / naveen

Depends upon application, EX: Acting load SG500, Over the
load SG400, dis SG based on the carbon Percentage & Chemical
properties& Mechanical properties.

Answer / prajapati piyush p.

to get maximum result and to minimize cost of casting.to select best working conditions.

What is shearing?

0 Answers  

---

what is mean by pitch diameter?

6 Answers   Greaves,

---

What is the difference between Mild Steel and Cast Steel with full chemical composition and application details.

0 Answers   DAE,

---

question related 2 soal car: Working under a bright light bulb or in direct sunlight, experiment with the angle of light hitting the solar panels. What angle gives you the fastest rotation of the wheels? How would you modify this car to make the wheels turn faster? How would you modify this design to make a car that could carry or pull a heavier load? How could you modify this design so that your car could run for short periods in complete darkness or low light situations?

1 Answers  

---

tansen was singer in whose mugal emperor

3 Answers   Concor,

---

Why the gear drives said to be power transmitting device?While it transmitting motion only.

2 Answers   Infosys,

---

if HP LP Bypass opened in running condition then what happen in 210 MW thermal plant

2 Answers  

---

If two cars hid each other will the speed increase or decrease?

3 Answers  

---

plz send me mahagenco previous exam paper on my email-id sameersatelkar@yahoo.co.in

1 Answers   ETA, MahaGenco,

---

Explain the procedure in staring a F.O. purifier

0 Answers   RRB,

---

What is the difference between isotropic and anisotropic materials ?

0 Answers  

---

which kind of force act when the piston slides inside the cylinder?and how to calculate that force or stress theoritically.

4 Answers  

---