Answer / ragavan

1. the power factor of a purely inductive load is zero.
because the phase angle between voltage and current is 90
degree electrical. hence power factor is zero.
2. in general star/star connection is used. this is
neutral terminal can be easily accessible both on hv and lv.

Answer / raghavendra

the power factor of a purely inductive load is Zero.

Star/Delta Type of transformer connection is preferred
in case of power supply transformers.

what is voltage rise and voltage drop?

8 Answers   HP, jetking, TCS,

---

how to calculate the current capacity of a wire if its dimension in Square mm is given

1 Answers   TATA,

---

where was current transformer protection units used and why??

0 Answers  

---

What is Chatoliq Protection ?

1 Answers   Chemanol,

---

Ehat is shunt motor?

4 Answers   L&T, Siemens,

---

how is reactive power controlled on the transmission system

2 Answers  

---

why do select 11000v rubber mat even we use only 415Volts

1 Answers   Saint Gobain, Tata Steel Limited,

---

Why we can't start a tube light without a starter(choke) and an inductor?

1 Answers  

---

what dose the arrow indicate in the symbol of power transformer?

1 Answers  

---

why is one voltage transformers (instead of three ) installed at the entrence of the incoming line in a substation.

2 Answers  

---

what is the MF if CT ratio is 500/5 and in meter specification is 3.75 REVS/KWH? Thanks and Regards Selvendran.N

1 Answers  

---

how is capacitor bank look like

0 Answers  

---