Answer / Jyoti Pal

HRG (Harmonics Removal Generator) and NGR (Non-linear Current Compensator) are two different types of devices used in electrical power systems, each with a specific purpose:

1. HRG: Harmonics Removal Generators are used to compensate for harmonics generated by non-linear loads in power systems. They operate based on the principle of generating currents at harmonic frequencies that are out-of-phase with the load currents, thereby reducing overall system distortion and improving power quality.
2. NGR: Non-Linear Current Compensators, on the other hand, are used to compensate for non-linear characteristics of loads by injecting a phase-shifted current into the electrical circuit. This helps maintain a more sinusoidal current waveform, thus reducing harmonic distortion and improving power factor."

Although both devices are employed in power quality improvement, their specific functionality and design differ significantly. HRG focuses on eliminating harmonics while NGR addresses the non-linear characteristics of loads directly.

How we can calculate the Amps for the cable Ex:- For 1sqmm wire how many amps we can draw (calculation)

1 Answers   TATA,

---

What are marginally stable systems?

1 Answers  

---

please tell me, how i clear the objective test? when i studied form the one book after i solved the objective ,that time i solved that qes. but if i tried solve objective form the other book then i could not solved these que.

1 Answers  

---

what is ATS & RING MAIN UNIT in Distribution System?And its Function.

1 Answers  

---

Give some differences between open loop and closed loop control systems.

1 Answers   GE,

---

what is the difference between 2phase & 3 phase?

1 Answers   NTPC,

---

A charge of 240 C is transferred in 2 minutes. The current flowing is:(a) 480A(b) 120A(c) 2A(d) 8A

2 Answers  

---

Tan delta point in transformer to be earth or not?

1 Answers   DMRC,

---

what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero

1 Answers   Jindal,

---

what is the working principle of UPS?

2 Answers  

---

why skin effect is decreases with decrease with frequency? why skin effect occur

5 Answers   Kirloskar,

---

i am electrical and elctronics engg passed out in 2009 want to attend for reliance placements.plz send me apttitude ,technical and hr question answers to my mail plz. my mail id-kat.bindas@gmail.com

1 Answers  

---