Answer / sayed usman

condition for syn DG
1 same voltage
2 same phase
3 same frequency
4 same phase angle

then u can syn 5 DG one by one

Answer / vinayakamoorthy.k

Conditions for syn.DG
1.Voltage must to be same
2.Frequency must to be same
3.Phase angle must to be same...
If the above three conditions are correct then u can
syncronise our DG set one by one...

Answer / c.dass

match voltage , frequency and phase angle and than
synchronise one by one.

What should be value of Circuit breaker operating time and tripping time?

5 Answers  

---

in flemings lefthand rule thumb indicate for....

2 Answers   APPSC,

---

what is motor contrl center .

3 Answers  

---

A wattmeter is marked 15 A/30A, 300V/600V and its scale is marked up to 4500 watt. When the meter is connected for 30A, 1600V, the pointer indicates 2000 watts. The actual power in the circuit in

1 Answers   Jindal,

---

what is differnce btwen lll and lllg faults

0 Answers  

---

how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you

0 Answers  

---

if flux and load static in dc motor and supply voltage increases 20% then what happened in speed

0 Answers  

---

What is the possible cause for failure of lightning arrestors in outdoor substation under normal condition

0 Answers  

---

can we use trip light with bus coupler?

0 Answers  

---

What is the difference between magnetic loading and electric loading of a machine?

2 Answers  

---

How do we check transformer losses and what are the ways to minimise it.

5 Answers  

---

How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?

0 Answers  

---