HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL

HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS
TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM ,
6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP
AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450
TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO
WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT
HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH
PROBLEM WITH FEW LT MOTOR ALSO.

Question Posted / alpesh chauhan

0 Answers
2000 Views
I also Faced
E-Mail Answers

No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More Electrical Engineering Interview Questions

Can I use RCCB in moisture control device in a submersible pump.

2 Answers TATA,

what is the criteria for selection of conductor used for ehv ac electrical dischrge

0 Answers National Productivity Council,

In directional earth fault protection for generator, one core balance CT is for residual current, what other CT is for, which is placed on neutral?

2 Answers

acsr dog conductor specification

1 Answers

How to calculate the 2500 Kva Transformer losses Primary 11KV Secondary 415volts

1 Answers Laurus,

what is the problem with single phase AC motors and how is it overcome?

2 Answers

Advantage of LT panel vs HT panel ?

1 Answers HCL,

what is meant by neutral Ct of a transformer and how it connected in transformer

4 Answers

What should be the conservator minimum oil level required in 2 mva transformer

2 Answers JSW,

Do you know how to measure the earth resistance?

7 Answers Manhattan,

what is meant by generator differencial protection?

1 Answers

What type of input will the OLTC indicator will accept or what type of output the OLTC will produce to monitor it's position at remote location.

1 Answers amps,

For more Electrical Engineering Interview Questions Click Here