Answer / kan allt

Because it is the SI unit for power.

Answer / tanmoy mete

BECAUSE IT IS DEPENDENT ON LOAD POWER FACTOR.

Answer / tanmoy mete

because active or real power is taken into account.

can anyone please help me to find the rupturing or breaking capacity in KA of circuit breaker (MCCB,VCB,ACB etc) of HT and LT side of a distribution transformer...please help with detailed step by step answer...thank you

0 Answers  

---

How many devices can be connected in one zone of FACP

0 Answers  

---

I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME

0 Answers  

---

difference between brush less & brush excitation in a generator?

1 Answers  

---

What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?

0 Answers   SCS,

---

---

what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me

0 Answers   Escorts,

---

How we calculat the NGR of 3phase Generator, Our generation voltage 11KV

0 Answers   MSP, Toyo Denki,

---

what are problems caused by the pdu in rack server

0 Answers  

---

FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?

0 Answers  

---

single phase 230v three phase voltage 415volt why we aren't used line voltage 690v?

7 Answers   Citec,

---

what is the difference between ground and neutral?

2 Answers  

---

what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.

0 Answers   Bhel,

---