Answer / aftab ahmed mazari

First you know which type of vibration probe you using.
Suppose you using proximity probe. Then check followings:
1. Its resistance, usually Bently Nevada common probes
restance varies from 4.5 ohm to 6 ohms. But if you using
asnother company probe, then see its literature.
2. Also make a graph of vlotage vesus distance of probe,
its behaviour should be linear.
3. If you have vibulator(Vibration source), then check it
with diffewrent vibrations.
aftabmazari@yahoo.com

why we are maintain the gap voltage in vibration probe when installing time can explain me?

1 Answers   CIL,

---

why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.

0 Answers  

---

What is a snubber circuit?

2 Answers  

---

I have flow transmiter DP range is 0 to 5000mmwc,(convert) Display to be show in m3/Hr.

3 Answers   Orient,

---

difference between vaccum and draft

0 Answers  

---

How can we calibrate pressure and flow transmitter in the field(online)?

3 Answers   Aramco, Reddy Labs,

---

Reasons for using current as signal

1 Answers  

---

what is differance  between SOE an alarams

1 Answers   BMM,

---

Why we use 250 ohm resister in series hart communicator?

3 Answers   Thermax,

---

Draw a group of instruments interlocked to a Pump & Motor?

0 Answers  

---

Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows

0 Answers  

---

Describe how to use megger to measure the earth resistance and insulation resistance

0 Answers  

---