How to run 1ph motor(230 VOLTS its full load amps is 4.5 ampa))with 480 volts m

How to run 1ph motor(230 VOLTS its full load amps
is 4.5 ampa))with 480 volts main(we didn hav
neutral)Thn we go for step down transformer.Our load 10
amps,so we conisder this amps in primary are secondary side?

Question Posted / fmcool75

1 Answers
3593 Views
I also Faced
E-Mail Answers

How to run 1ph motor(230 VOLTS its full load amps is 4.5 ampa))with 480 volts main(we didn hav ne..

Answer / parminder

YOU CAN STEP DOWN VOLTAGE TO 110 V THEN CAN RUN MOTOR ON TWO
PHASE.

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

What are the reasons for AVR failure in LT DGsets ?

2 Answers

why grid failure happens?

1 Answers

In parallel operation time both NGR’s close or not close if both close what will happen

0 Answers

Basic motor transformer generator

0 Answers eCentric Solutions,

How we calculate the size of H.T cable for any transformer & rating of busbar for any L.T. panel?

3 Answers

is it possible to flow a current between nutral and earth in a circuit? although nutral and earth having same potential diffrence? i=0/r=0A if any body now any solid reason because i am getting a triping problem in rcbo due to nutral and earth shorting???

2 Answers

How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?

0 Answers

what will be the efficiency off x'mer during no load test and during short circuit test

1 Answers GPSC Gujarat Public Service Commission,

If the circuit breaker will not close or it will trip, what will you do?

3 Answers

We have a 1275KVA existing Transformer in a power plant project. Customer want to get it test & confirm whether it is a Dyn1 Transformer or not. Pleae let me know how to test it.

1 Answers Allied Group,

What is Specific Gravity of the Electrolyte used in Lead Acid Battery????What is Unit????

7 Answers Emerson,

I have connected 04nos. earthings to a transformer through 04nos. earthing pits seperately. 02nos. earthings are connected to T/F body, and 02nos. earthings are connected to T/F neutral.T/F capacity is 2000KVA, 11KV/415V. But after completing of 02 years successful operation ,we are facing following problems- 1. CT/PT occured blast one time 2. HT cable box occured blast two times 3. One body earthing strip and one neutral earthing strip of transformer are overlapping at some places. Whenever these two strips are pressed at overlapped points, they made spark. What is the reason of spark? Please explain the reason & rectification of above problems

5 Answers

For more Electrical Engineering Interview Questions Click Here