In ship cranes, there is a provision of providing a conveyor for the cable. The

In ship cranes, there is a provision of providing a conveyor
for the cable. There is no provision of slip ring.
How is it possible?

Question Posted / shivang

2 Answers
7483 Views
L&T, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

In ship cranes, there is a provision of providing a conveyor for the cable. There is no provision o..

Answer / thulasi raman

There r Slip ring arrangement in cranes onboard ships. the
slip rings are present within the crane which is not seen
from outside. the power lines pass throough the centre of
the crane through slip rings. The power line u see out side
is only for grab which comes through the torsion clutch. If
there is no slip ring arrangement the crane cannot turn 360
degrees.

Is This Answer Correct ?

6 Yes

0 No

In ship cranes, there is a provision of providing a conveyor for the cable. There is no provision o..

Answer / kumaresan

The above answer is correct the purpose of slip ring is to
avoid twisting of electrical cables and damage to occur.

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Marine Engineering Interview Questions

describe excessive vibration of a machinery that not always apparent? state and explain that the vibration are transmitted from elastic materials or components to another?

0 Answers

What is meant by ‘superheat’?

0 Answers

What does 7L67GFCA stands for in a marine engine MITSUI?

0 Answers

Dear sir i complete my BE marine wit 75% in 2012 But still i can`t able to job so i decided leave the search job related marine please guide me ...................

0 Answers

What is overhauling and record kelping? What is the prosecute of dismantling and assembling?

0 Answers Maritime Academy,

Show the sinosoidial effect built in a generator with the help of a diagram?

0 Answers

what is motor bike c.c.

6 Answers

What is meant by Centre of Buoyancy?

0 Answers

Difference between RTA, RND & RD marine diesel engine?

0 Answers

how the priming is done in a centrifugal pumps?