what is motor bike c.c.
Answers were Sorted based on User's Feedback
Answer / saeedraja
CC or cubic centimeters refers to engine capacity.
Specifically it refers to the amount of air/fuel mixture
able to fit into the cylinders (where combustion occurs) at
full expansion. 1 cc is equivalent to 1 gram of water aka 1
ml.
An example: 250 cc engine means the cylinders with pistons
at full expansion can hold a volume of 250 ml of air/fuel
mixture prior to the combustion stroke
Is This Answer Correct ? | 25 Yes | 2 No |
Answer / likhitha
cc refers to the engine capacity which is nothing but the
volume which is available for the storage of fuel/air. The
full form of cc is cubic centimeters ,as referd earlier cc
isnothing but the units of volume.Hence cc is directly the
volume of the fuel/air tank.
Is This Answer Correct ? | 8 Yes | 2 No |
Answer / ketan patil
It is the volume of engine from tdc(top dead center) to bdc(bottom dead center) of engine.
Volume= stroke length(cm) x cross section of area of cylinder(cm2)
Is This Answer Correct ? | 0 Yes | 0 No |
star connection for a 3 phase induction motor gives reduced starting current.but 1.732 times the rated current during run up period if the motor was designed to run on delta. Why can't we design the motors to run on star connection instead. It will remove the starting arrangement required making the construction an operation much simpler.
1 Answers Synergy, VR Maritime,
how to find natural frequency of segmented ship model? (in air and water)
2 Answers Auckland University of Technology, SCI,
Which is the largest ship repairing hub in india
Find the area of the disc at 62 c whose diameter is 3.4m at zero degrees celsius. Linear coefficient of expansion is .0000118 per degree c.
Name different types of ships?
What is the purpose of o-ring, wearings in the centrifugal pumps?
how many types of ships?
Difference between MAN and REVERSING SYSTEM?
how many ports are there in india
what is high temperature corrosion and what is center priming.
A steel column 3 m hight is of hollow square section, 200 mm outside dimension and 20 mm wall thickness. (young's modules E=210*10^9) calculate A: the compressive load which will give a stress of 60 MN/m^2 in column. B: the compression o the column under the load in (A).
Difference between gate valve and globe valve?