Answer / bala_vlsi

you can easily find out 1U 1V 1W - This is HT side and 2U
2V 2W this LV side

Answer / nithi

for a distribution transformer(22 kv or 11kv/440v),there is
a bushing in the HV side whereas LV side doesn't has.
in a small transformer (used in radio,tv....),the
size of the lv side winding (conductor size)is slightly
bigger than the HV side winding.

Also,HV winding is always wounded over the LV
winding.

Answer / m.saravanakumar

The LV side mostly STAR winding, That's why which has four Bushings that is R, Y, B phases and neutral. But in HV side mostly Delta winding that's why which has three bushings.

Answer / k.prakashchandra

In power trs, the size of the bushings

Answer / balasimha rao

for any distribution transformers there are three bushings
on HV side and four bushings on LV side

Answer / mubasher

Try to see the connected cables if you can distinguish between HV & LV cables
HV side there is only one big cable which is multi core and LV side three separate cables and neutral cable
if there are no connected cables then see the glands available for cables; at LV side there is provision of single gland and at LV side there is LV cables termination box.

Answer / nithi

yes prakash..good back up..u are absolutely right..

In CT's they mentioned 400/5 or 1250/5, 1000/1 here 400,1250,1000 is Breaker Capacity what is the /5 Explain me briefly

2 Answers  

In synchronous motor, how the field current is related to armature current..i know its inversely proportional..but concept wise...i was nt clear....pls help me...

0 Answers   Siemens,

In 110V DC supply,if a closed circuit gets open, How can we identify the voltage which is measured after the resistor(4KOhm) which is open with negative.it shows 55V +ve when measured, also the actual positive source is 55V +ve .Because there is no voltage drop in open circuit. How can we identify whether this is the voltage which is series with the resistor or the DC source direct +ve.

1 Answers   GE,

What is working Priniciple of TVSS ????

1 Answers   Emerson,

From stability point of view,What(higher/lower) should be the value of inertia constant of rotating machines?

1 Answers  

What is the difference IN MCCB's between thermal magnetic and electronic tripping system ?

0 Answers  

How size of Earth Strip is determined for a particular Fault current.

1 Answers  

what is the difference between droop mode and ischnorous mode in thermal powerplant?

0 Answers   GVK, Thermax,

what is the all safty name of diesel genrator?

2 Answers   Adani,

How to improve fuel cell in a distribution system?

0 Answers  

an off load but energized 11/0.4 KV, 1250 KVA T/F has a power factor of 0.65(capacitive)..!! why is it so, though T/F being an inductive device ??

4 Answers  

We have two Al.busbars each of size 125mm*10 mm connected in parallel.To increase the current rating ,can we connect third busbar of size 100mm*10mm in parallel to existing two busbars?In my opinion ,if we connect busbars of different sizes in parallel,then the busbar of lowest size will take much current.So this type of paralleling should be avoided .Am I correct?

1 Answers   PDP Steel,