my question is Megger of cable insulation or swgr board
meggerring some values in one day 50mohms,some other day
checking different values(20Mohms).
this tell that some person tell that that values ok.
how to identify the megger value is correct.
pls tell me the answer.
Answers were Sorted based on User's Feedback
Answer / akhil.goyalanager1985
the megger value show the dielectric strength of the
insulation .through megger we conclude that the
deterioration of the insulation. & the value of megger
shoulb be greater than
2*kv+1=Mohm
As per therotical point of view .
| Is This Answer Correct ? | 2 Yes | 1 No |
Answer / mukesh thakur
if you are asked to charge a m/c urgently, you can go for dummy charging using 3-phase load through a, say 16A MCB, and if the MCB does't trips then there is no problem you can go for permanent charging.
| Is This Answer Correct ? | 0 Yes | 2 No |
in our all power plant have connected in grid and grid voltage and plant voltage is same, but as per as electrical concept the power will transmit from high potential to low potential but here altough same,then how power transmit from power plant to grid.
Is MV canble armour can be earthed at both ends?
what do u mean by starting torque? how it should be for a good motor? what is the relation between starting torque and power factor? What is the relation between efficiency and starting torque?
At light load transformer efficiency is less because A secondary output is low B transformer losses are high C fixed loss is high compared to output D copper loss is small
What is force on parallel conductors ?
Why air circuit breaker off due to power failure?
If I want to use capacitor banks at HT (11 KV) side for maintaining power factor then which type of capacitor should I use? Plz give me the specification?? (I am using 1250 Kva transformer (11 KV/433V)).
power factor is max for which welding a.arc b.resistance c.gas
can i have the methods of speed controls for 3 phase AC MOTORS.
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
For a CT the number of turns in the primary winding is.........
Can somebody tell me the type and amp of transformer used to implement 600VA UPS? Thanks in advance.
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)