How to analyse the best accuracy to micrometer than vernier?

How to analyse the best accuracy to micrometer than
vernier?

Question Posted / rajiv kumar

4 Answers
7822 Views
IOCL, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

How to analyse the best accuracy to micrometer than vernier?..

Answer / pratik patel

-->Vernier Has Least Count of 0.02 mm (Least count is
minimum unit that can be measured)
-->Micrometer comes with Least Count of 0.01 mm. so
obviously micrometers are more accurate. One benefit of
Micrometer is that, they come with THIMBLE for uniform
pressure, In vernier you will get different reading for
different pressure of your thumbh. The difference will not
be much but if you talk about accuracy it will affect.

Is This Answer Correct ?

11 Yes

1 No

How to analyse the best accuracy to micrometer than vernier?..

Answer / subham

~micrometer have a rotary handle and whereas vernier have a slider.
~micrometer for measuring diameters and vernier for inside outside diameter as well as depth.
~A typical micrometer screw guage has a maximum accuracy of +or-0.0005mm(0.01mm)reading whereas a veriner caliper has a typical maximum accuracy of +or-0.05mm(0.1mm) reading.

Is This Answer Correct ?

3 Yes

1 No

How to analyse the best accuracy to micrometer than vernier?..

Answer / ghanshyam

By Least count

Is This Answer Correct ?

1 Yes

0 No

How to analyse the best accuracy to micrometer than vernier?..

Answer / okwu victor

Micrometer screw
guage is more accurate
than callipers because
micrometer has more
significant figures than
callipers

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Mechanical Engineering Interview Questions

What is mean effective press?

2 Answers

the funtion fly wheel?

9 Answers APGenco,

Hai, i am going to appear for Section Engineer- Mechanical,RRB Chennai.Can anybody please post me the previous question papers and solutions to ajeshsudhakaran@gmail.com....

0 Answers

what is blow by and blow down phenomena in ic engine?

3 Answers L&T,

What is the selection criteria of Natural Draught Cooling Tower and Induced Draught Cooling Tower . Where we prefer NDCT and where IDCT.

4 Answers IRCTC, Lanco,

what is ERW PIPE & Seamless PIPE Out of ERW and Seamless which one gives good results for an impact force of 2700 N??

2 Answers NTPC,

Explain the uses of windmill?

0 Answers

explain bicycle rear wheel sprocket working?

1 Answers

What causes white smoke in two stroke locomotive engines?

0 Answers

what is bearing stress?

4 Answers

what is BOOSTER pump which is used in power plant?

4 Answers

length l and width b is given for a rectangle.and the perimeter of a rectangle is denoted by p.another rectangle length is 2l and width is 3b and the perimeter of a rectangle is p1.find the ratio between those two perimeters?

1 Answers

For more Mechanical Engineering Interview Questions Click Here