If We are converting the SINGLE PHASE AC into THREE PHASE AC
by using STATIC CONVERTERS , then How do we bring the
frequency to 50 hz??
Answers were Sorted based on User's Feedback
Answer / r.praveen durai
May be by VOLTAGE FREQUENCY DRIVE (CYCLOCONVERTOR).
Is This Answer Correct ? | 1 Yes | 0 No |
wat is syncronization . wat parameter will take for syncronization.
What is stepper motor. What is its uses?
The ohm is the unit of:(a) Charge(b) Resistance(c) Power(d) Current
what is the use of sdf?
what are the compensations considered while designing a transmmision line.
I am an electrical power engineer and arranged power system for a data center, I installed MCB, ELCB and erthing system TN-C-S. But some times several ELCBs Disconnect circuits at the same time! what may be the reason? (the ELCBs are 25A ,30mA)
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
What is a feedback in control system?
Triping principle of ELCB&RCCB? wht is the difference between these two?
What is mean by % impedance of transformer? detail explanations expected.
if receiving voltage is higher than sending ones what will be the effect of receiver
7/20,3/20 electrical wire is specified as stated.Why?