sir, What is the purpose in Generating power plant is operated Lagging PF and

sir,
What is the purpose in Generating power plant is operated
Lagging PF and Above 0.9 lag PF?

Question Posted / guest

3 Answers
6026 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

sir, What is the purpose in Generating power plant is operated Lagging PF and Above 0.9 lag PF?..

Answer / jeet

It is basically for the purpose to reduce transmission losses

Is This Answer Correct ?

1 Yes

2 No

sir, What is the purpose in Generating power plant is operated Lagging PF and Above 0.9 lag PF?..

Answer / ssssss

at the power factor near to unity there are no transmission losses and the plant capacity also increases

Is This Answer Correct ?

0 Yes

1 No

sir, What is the purpose in Generating power plant is operated Lagging PF and Above 0.9 lag PF?..

Answer / satendra

We have to supply the power to the grid. So there is a capacitance is developed due to the high voltage lines and the earth surface. so in turn the voltage will increase till it reaches to the grid so maintain the required voltage we transmit it at a lagging power factor.

satendra.svnit@gmail.com

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

what are the type of motors

3 Answers

what is the difference between home inverter and online ups?

2 Answers ME,

234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,

0 Answers Jubail O&M,

why we use 6nos of C.Ts on 11kv incoming?

2 Answers

why only exciting current is shown not primary current in transformer???

0 Answers

What are the main factors to be considered(In terms of energy conservation) while selecting a new air compressor?

1 Answers

Why electrical heaters are not provided with overload relays in circuits

1 Answers

KVAR Kilovolt-Ampere-Reactance

2 Answers

how did i get the competency certificate as electricle supervisor. iam completed my b.tech.but i dnt have any experince, this certificate is required for applyng ongc mangement trainees. what should i do sir please suggested me

0 Answers ONGC,

If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..

0 Answers Bhel,

Is better to supply the voltage for static exciter from the auxiliary power source or from the SG terminals? And why?

0 Answers

why normally Generator rating are between 11Kv to 22Kv?

7 Answers Torrent Power,

For more Electrical Engineering Interview Questions Click Here