how to calculate the earth mat design in 132 kv substation
yard ????



how to calculate the earth mat design in 132 kv substation yard ????..

Answer / Shalini Verma

Calculating the earth mat design for a 132kV substation involves several steps, including soil resistivity testing, ground grid layout design, and calculation of required earth electrode size. You can refer to IEC 60364-5-1 (International Electrotechnical Commission standard) or ANSI/IEEE C270 (American National Standards Institute / Institute of Electrical and Electronics Engineers standard) for detailed procedures.

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

What is the type of electrical motor used in mining industries?

2 Answers  


230v AC & 230V DC which is more dengerous for getting a clectric shock between this two voltage?

5 Answers  


what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?

1 Answers   TNEB Tamil Nadu Electricity Board, Vestas,


What is the criteria for selecting the voltage classes of an AC Induction Motor.The KW rating above/below which ht/lt selection is made may be provided in details.

1 Answers   DAE,


Why 30°phase shift occur in star-delta transformer between primary and secondary?

1 Answers  


best manufacturer for busbar for outdoor switchyard having double bus bar scheme, can any one share technical specification of busbar. 132kv voltage ?

1 Answers  


can we ran equipment up to 10kw between phase to grounding/ earthing. beside above can we use grounding instead of neutral. .

1 Answers   TNEB Tamil Nadu Electricity Board,


LT, CC and LMU installed at both the outgoing circuits of 132 kv double ckt transmissio what its means ? and what are there use ?

1 Answers  


defined power system?

3 Answers   Spanco,


I am an electrical power engineer and arranged power system for a data center, I installed MCB, ELCB and erthing system TN-C-S. But some times several ELCBs Disconnect circuits at the same time! what may be the reason? (the ELCBs are 25A ,30mA)

9 Answers  


Where there is voltage,there must be current.Is this right or wrong??

10 Answers  


What is T’Q and X’Q and X’D ? and what is saturated as well as unsaturated ?

1 Answers   XX,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4453)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)