in construction feild make the column rods are uneven ( e.g
1 column we have 6 nos of bars that 6 nos of bars are
varrious level- 1 bar 10';2 bars 9';3 bars 8') what is
resion to put different level if difference are required or
not?

Answers were Sorted based on User's Feedback



in construction feild make the column rods are uneven ( e.g 1 column we have 6 nos of bars that 6 ..

Answer / dheeraj singh

yas diffrence lvl r requird , resion is this as per IS 456,
overlap of the column not to be place not more than 50% at
a section, so that we put the diffrent level of the column
bar to aboid the 100% over lap at any section of column.

Is This Answer Correct ?    2 Yes 0 No

in construction feild make the column rods are uneven ( e.g 1 column we have 6 nos of bars that 6 ..

Answer / santosh singh

the steel rods should be in zig-zag position and all the
steel rods should be over lapped at different places.
the steel rods should be minimum 300mm in level difference
and the lap should be provided iner centre of column

Is This Answer Correct ?    3 Yes 2 No

in construction feild make the column rods are uneven ( e.g 1 column we have 6 nos of bars that 6 ..

Answer / suresh

uneven level is not required.technically nothing mater.

Is This Answer Correct ?    0 Yes 7 No

Post New Answer

More Civil Engineering Interview Questions

how many bags of cement,sand and Aggregate to p.c.c. of 1:2:4 ratio.

4 Answers   Isaac Designs,


Why camber is provided?

2 Answers   G R InfraProjects, Tata Steel Limited,


What is rate for brick masonry work of 1.0 m3 in cm 1:6?

0 Answers  


what do you mean by ssd how it calculated

3 Answers  


How many weight per 1meter cube of concrete for column.

4 Answers   JK Lakshmi Cement,






I want to construct 1850 square ft of rcc apartment , with stilth parking , the site requires 18 ft of pile foundation , the apartment will be above ground parking , can some one guide me about the cost of construction of such structure in Pune ?

1 Answers  


What is capicity of cap lock scffolding stander(vertical member) and ledger of different size?

0 Answers   Gammon,


I want to know the material required per Square foot in rcc roof i.e.Steel ,Cement,

0 Answers   Das Infratech,


material calculations for I st coatplastering 16mm CM (1:5),second coat CM(1;3)4mm thick,pcc(1:4:8),RCC M20,lime stone masonry CM(1:6)

1 Answers  


What is the difference between opc cement to ferro cement

0 Answers  


what is the safe bearing capacity of hard murum? can we consider it 50 ton?m2

1 Answers  


which has high coefficient of discharge venturimeter or orificemeter

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)