In 110V DC supply,if a closed circuit gets open, How can we identify the voltag

In 110V DC supply,if a closed circuit gets open, How can we
identify the voltage which is measured after the
resistor(4KOhm) which is open with negative.it shows 55V +ve
when measured, also the actual positive source is 55V +ve
.Because there is no voltage drop in open circuit. How can
we identify whether this is the voltage which is series with
the resistor or the DC source direct +ve.

Question Posted / ramniveth

1 Answers
4498 Views
GE, I also Faced
E-Mail Answers

In 110V DC supply,if a closed circuit gets open, How can we identify the voltage which is measured ..

Answer / k.prakashchandra

Apply a load and measure voltage

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

where the Motorized mccb to be used? In Motor control center panel starters ,it is use full. please answer

1 Answers Voltas,

How will you Physically differentiate A.C and D.C motor?

10 Answers BSNL, Polycab,

Mention the methods for starting an induction motor?

1 Answers

What is OLTC in transformers and what is its function?

4 Answers

why cont we short earth and N.......?

3 Answers

The capacitive reactance of a capacitor of 1/(2(PI)) F at 10^3 H is

1 Answers

How to calculate voltage drop loss in HT 11000 Volts XLPE Aluminium conductor cable. Any specific formula or Thumb rule

2 Answers

Why breakers not synchronized when the synchroscope is going in the anticlockwise direction?

2 Answers

what is the working principle of contactor and conditions of normal open and normal close on it?

3 Answers EEE,

wat is the importance of reactive power in power generation.....if it is zero means wat will happen to system........

22 Answers Bhel, Jindal,

Our Company's Contract Demand is 110 kVA. We use 12 Capacitors each of 12.5 kVAr Capacity to maintain Power Factor of 0.99. So, what steps should we take so that our Contract demand does not exceed 110 kVA?

1 Answers Jindal,

What will be the diameter of pipe between conservation tank and transformer

1 Answers JLL,

For more Electrical Engineering Interview Questions Click Here