Answer / Priti Rani

Communication between Citect and Siemens S7 controllers typically uses the PROFIBUS or Ethernet/IP protocols. Here's a basic overview of the address considerations for DI, DO, AI, AO:

1. Digital Input (DI): Addresses range from 0 to 65535 with an even number starting at 2 (reserved for emergency stop). The bit number within the address determines the specific input channel.

2. Digital Output (DO): Addresses range from 0 to 65535 with an odd number starting at 1 (reserved for diagnostic output). The bit number within the address determines the specific output channel.

3. Analog Input (AI): Addresses range from 0 to 65535, usually in multiples of two starting at 2. Each AI consists of two 16-bit words: one for the lower 16 bits and another for the higher 16 bits.

4. Analog Output (AO): Addresses range from 0 to 65535, usually in multiples of two starting at 2. Each AO consists of two 16-bit words: one for the lower 16 bits and another for the higher 16 bits.

Why virtual corporation is used?

1 Answers  

---

THERE IS A SQUARE ABCD. A LINE AF IS DRAWN FROM THE POINT A TO POINT F WHICH LIES ON THE LINE OF THE SQUARE BC AND ANOTHER LINE DE IS DRAWN FROM THE POINT D TO POINT E WHICH LIES ON THE LINE OF THE SQUARE AB. THE LINE DE AND AF INTERSECT AT O. IT IS GIVEN THAT AE AND BF ARE EQUAL AND AO IS 4cm AND AE IS 5cm. FIND EO.

2 Answers  

---

what is fixed bearing?

1 Answers  

---

What is process planning?

1 Answers  

---

Tell me full description about wonderware Application?

1 Answers  

---

give comparison of three wire & two wire sensors.

1 Answers   Samtel,

---

Do you know which company's bricks need brick making machine?

1 Answers  

---

hye SAM CAN U SEND YOUR E MAIL ID. so that i can contact u directly on e mail.

1 Answers  

---

what are v/f control, sensorless control and sensored control for AC VFD?

1 Answers   Crompton Greaves, Surya Nepal,

---

i have one air blow heater , coiled heater is in side hollow ceramic tube and passing the air and other end hot air is going out, to control the hot air where i should fix up a THERMOCOUPLE on the heater or on the out let of hot air terminal which is the best way

1 Answers  

---

Why control valves are hunting on manual mode?

1 Answers   KBT, Sabic, Sun Operation,

---

Can you calibrate, troubleshoot and repair instruments? Which tools do you use for the same?

1 Answers   Focus,

---