ANY ONE USED/INTERFACED CITECT VERSION 6.0/1 OR 7.0/1 TO
SIEMENS S7-300 OR S7-400 CONTROLLER IF PLEASE TELL ME THE
COMMUNICATION STRUCTURE AND ADDRESS CONSIDERATION FOR
DI,DO,AI,AO
please mail the details lok_pallapolu@yahoo.com
Ph:09247513753
hyderabad
- 1 Answers
- 2170 Views
- I also Faced
- E-Mail Answers
Answer Posted / Priti Rani
Communication between Citect and Siemens S7 controllers typically uses the PROFIBUS or Ethernet/IP protocols. Here's a basic overview of the address considerations for DI, DO, AI, AO:
1. Digital Input (DI): Addresses range from 0 to 65535 with an even number starting at 2 (reserved for emergency stop). The bit number within the address determines the specific input channel.
2. Digital Output (DO): Addresses range from 0 to 65535 with an odd number starting at 1 (reserved for diagnostic output). The bit number within the address determines the specific output channel.
3. Analog Input (AI): Addresses range from 0 to 65535, usually in multiples of two starting at 2. Each AI consists of two 16-bit words: one for the lower 16 bits and another for the higher 16 bits.
4. Analog Output (AO): Addresses range from 0 to 65535, usually in multiples of two starting at 2. Each AO consists of two 16-bit words: one for the lower 16 bits and another for the higher 16 bits.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what are the different ripple removing circuit . which one is better and why
what is alternater & engine genral protection?
can you give me the solution of iiie
plz send me l&t auestion papers. i have been called for written and interview industrial automation 2 yrs exper. send me on mail pal_deepak06@yahoo.com
Anyone answer what is average cost for 1 meter GI pipe Hot dipping
