Answer / surendra4577

EXPANSION JOINTS:
Expansion joints are constructed to allow the expansion of concrete in summer. If we do not provide these joints there will be development of unnecessary stresses in the pavement.

CONTRACTION JOINTS;
Contraction joints are used release the temperature stresses. In summer temperature stresses are contraction. so there is no problem of temp. stresses as total design stress is reducing with increasing in compaction stress.
but during winter tem. stresses are tension type. design stress or critical stress is more with increase of temp stress . That's why we should have small length panels.so we provide constraction joints.

for 200 kg of cement how is the mix proportion in kg for m25 grade of concrete

0 Answers   Indlands,

---

what is water cement ratio m10,m15,m20,m25,m30,m35,m40

1 Answers   Quaid-e-Azam International Hospital,

---

What is cutting Length of stirrups of a beam 300mm*300mm.

3 Answers  

---

What are the methods in tiles flooring ? What are the methods in brick work? What are the methods in plastering ? What are the methods in wall tiling?

0 Answers   CECL, HTC,

---

Formula for calculating the volume of bulb in underreamed pile

0 Answers  

---

Design a shear wall of length 4.20 m and thickness of 250mm subjected to the following forces.Assume Fck = 25Mpa and Fy = 415Mpa and the wall is a high wall with central part 3440mm x 250mm and two 380mm x 760mm strong bands at each end with following loading. S.No.       Loading        Axial force      Moment     Shear 1               DL+LL          1950              600            20 2           Seismic load       250              4800          700

0 Answers   L&T,

---

mix design ratio of M30 concrete

1 Answers   KITL,

---

Please tell me 1 Sqm Steel 14mm center to center .200,.200

2 Answers   Al Shalawi,

---

cement mortar 1:6 explain the cement and sand coefficient calculation?

1 Answers   Mega Builders,

---

can i place column steel lapping in floor beam? my lapping is 24 inches in floor beam and 24 inches on floor beam

1 Answers  

---

how to calculate the length diamond shaped striupps in column

0 Answers   Marg,

---

What should be the lap length in raft if height of raft is 0.800mm ...it couldn't b 50D or 40D...we just have to join upper and bottom reinforced...is there any formula for determine it...

0 Answers   SIPL,

---