Why does inductive loads consume KVARs?
No Answer is Posted For this Question
Be the First to Post Answer
State kirchoff voltage law?
i need to connect fact device(any one from following upsc,sssc,svc,statcom and tcsc)in 14 bus system....by using MATLAB psat software....if i connect these fact devices,i will get some error as "virtual error"...i cnt rectify this error.if anybody know that how to work in psat,pls help me to rectify this error.... or send mail me to, viki0607@yahoo.co.in
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
why impedance test in power cables?
where would be tap changer in transformer & why?
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
What is fault level?How it is calculated and how it is Expressed?
What are the main significances of root locus?
What is the fuction of UV & how it works in circut breakers? is it one type of relay?
how to select the power contactor in Diffrent AC motors.
what is difference between MCB & MCCB
if voltage in transmission line more than current will be more or less,if less what about the Ohm's law
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)