Answer / naresh dhiman

while taking a turn, tourque transmitted to the inner wheel
is more as the meshing of the star and sun gear comes more
close and meshing with outer wheel is loose which gets free
to rotate MEANS inner wheel rotate by engine power and
outer wheel rotate freely

Answer / muthuselvam

it is used for four bevel gears .two gears are connected in
stub axle of out side wheel and two gears are supporting
gears.it is transmitted the power from gear box to rear
axle same and constant speed...........

Answer / k. murali

while a vehicle take turn the inner wheel rotate slower than the outer wheel, to avoid skid.

Answer / mohankumar

Car wheels spin at different speeds, especially when
turning. You can see from the animation that each wheel
travels a different distance through the turn, and that the
inside wheels travel a shorter distance than the outside
wheels. Since speed is equal to the distance traveled
divided by the time it takes to go that distance, the
wheels that travel a shorter distance travel at a lower
speed. Also note that the front wheels travel a different
distance than the rear wheels.

Answer / amit rajput

its basically used in turnin 4 a 4 wheeler....it consists of
4 bevel gears dat r connectd 2gether....n while takin a turn
d inner wheel has to rotate wid smaller radius n d bigger
wheel wid mr radius....so DGB is used for smooth turnin....

What is hammering in steam or water flow pipe line. how it is happening.

3 Answers  

Does the position of a chicken egg affect the amount of weight it can withstand?

0 Answers  

What is coefficient of performance?

2 Answers  

how we can avoid gas bubble s formation while mixing high viscous liquids?

4 Answers  

generally in reaction turbine, only a part of pressure energy is converted into kinetic energy. whaat about balance pressure energy incase of single cylinder steam turbine?

1 Answers  

What do you understand by heat treatment?

0 Answers  

WAHT IS THE DIFFERENCE IN IS2062 AND IS1239

1 Answers  

• Why not 4 phase & 5 phase

0 Answers   NTPC,

what does the nomenclature for this bearing mean? 3206etvh.c3

1 Answers   Bruce Power,

what is EN in pipes property?

0 Answers   ONGC, Petron ltd,

IF RPM OF PTO OF TRACTOR IS 540,torque at pto is 21kg/cm sq.& WE NEED IT TO 1800 RPM ,THROUGH GEAR ONLY FOR THAT WHAT WOULD BE ETHE GEAR STRUCTURE( I.E.NO TEETH OF BOTH GEAR ) IN ORDER TO GET 1800 RPM OUTPUT.

0 Answers   Eicher,

what is the difference between Positive displamcement pump and centrifugal pumps?

1 Answers